Garage door won't close: sensor repair in Upper Montclair

A door that starts down and comes straight back up is nearly always telling you about its safety sensors.

Call (862) 310-6302

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Upper Montclair repairs the sensors and re-tests the opener's safety system.

Belt-drive garage door opener on the ceiling rail

Doors that won't close in Upper Montclair

More than four out of five houses in Upper Montclair were built before 1940, and most of their garages are detached, at the end of a long shared or narrow driveway. Around Anderson Park and Edgemont Park, and along Upper Mountain Avenue, these are old wood buildings with settled floors, so the sensors are rarely level with each other. They are also used mainly for storage, and the beam gets blocked by whatever was put in last. On the Montclair State side, hillier lots send runoff to the door. Near Valley Road, space is tight. The neighborhood's huge old trees bury doorways in leaves each November.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Quick things to rule out

  • Is anything in the path of the beam, even a leaf or a cobweb?
  • Are both sensor lights lit and steady?
  • Does the problem only happen at one time of day? That points to sun in the sensor.
  • Is the wall control's lock or vacation button switched on? It disables the remotes.

Anything beyond that, including limit and force adjustment, is a job for a technician, because a wrong setting can stop the door from reversing when it should.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Upper Montclair

  • Upper Mountain Avenue: Larger homes on the slope of the mountain, with steep drives.
  • Montclair State side: Northern streets near the university with a mix of older and mid-century homes.

See the full Upper Montclair service area.

Leave the door where it is and call.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (862) 310-6302
Call (862) 310-6302